Video Tutorials

Episode 5 | Creating the Legs

In this episode we will create and mirror the legs of the electric motor.

Draw out the main sketch of the motor legs. This will be on an offset construction plane. Finish off the leg design by cutting away some holes and filleting some edges. Finally use mirror to create the second leg. NOTE: sketch a 80mm circle, not 90mm.

All videos on Electric Engine

Episode 16 | Fitting screws

We will add final touches to electric motor design and add the remaining bolts to our finished design.

6:07

Episode 15 | Fan Pattern

We sketch out a complex sketch using Copy and cut away the fan pattern on the end cap.

4:05

Episode 14 | Mirror the Front Cap

In this lesson we will mirror the front cap and bolts to create the back cap.

4:13

Episode 13 | C Hook

We will create the C hook using Sweep and will Translate it into the C hook mount.

3:29

Episode 12 | C Hook Mount

In this lesson we will create the C hook mounts.

4:46

Episode 11 | Union to Combine the Frame

In this lesson we will learn the Union command to combine bodies.

1:26

Episode 10 | Screws

We will create the screws, insert them into the motor and make copies using Transform/Translate.

4:53

Episode 9 | Main Shaft

We will create the main shaft and will transform it into the motor frame.

3:18

Episode 8 | Section Views

We will learn about section views and how they can be used within Shapr3D.

2:06

Episode 7 | Terminal Cap

We create the terminal cap and discuss the difference between using push to extrude and standard extrude tool.

3:33

Episode 6 | Terminal Box

We will learn replace face when trying to extrude our sketch up until the revolve surface.

2:47

Episode 5 | Creating the Legs

In this episode we will create and mirror the legs of the electric motor.

5:46

Episode 4 | Creating the Fins

We will sketch the fin, extrude it and copy to generate all fins around the main frame

4:33

Episode 3 | Hubs

In this episode we sketch the hub design to be used to bolt our end caps to our main frame

5:34

Episode 2 | Revolving

Once completed the main sketch, we revolve each of the 3 sketches to generate 3 unique bodies

3:09

Episode 1 | Main Sketch

The main sketch will be a revolved sketch for the motor frame and end caps

5:06